![]() Nowadays, many monuments are iron pins or concrete posts installed by surveyors or by the U.S. Of course, for a metes and bounds description to be legally sufficient, the location of the POB must be specified, and is usually specified by a monument (aka landmark), which can be a large artificial or natural object or other stable structure, including rocks, trees, streams, railroads, roads, and intersections that are recorded by surveyors to locate property. This continues to the point of end ( POE), which is identical to the point of beginning, since all properties must have enclosed boundaries. Starting at the POB, the length of each boundary is described and the angle that it forms with the previous boundary. A mete is a boundary line and bounds is the area enclosed by the metes - hence, the name. A metes-and-bounds description uses lengths and angles of boundaries starting at the point of beginning ( POB). Metes-and-bounds descriptions were used in the original 13 colonies before the rectangular survey system was developed. There are 3 independent methods that can be used to determine the exact location and boundaries of a parcel of land: Legal descriptions always note the county and state in which the property is located. The Federal Bureau of Land Management and the USDA Forest Service are developing a National Integrated Land System (NILS), using common methods nationwide based on new technology and software to record the survey data and other information for land records. Today, the accuracy of property descriptions is greatly enhanced using computers, satellites, lasers, and global positioning systems (GPS). ![]() If the location, size, and shape of buildings on the lot are also given, then it is called a spot survey. ![]() The surveyor prepares 2 documents: a survey that gives the property's description and a survey sketch that shows the location and dimensions of the parcel. Only a licensed surveyor should prepare property descriptions, since inaccuracies can cause title problems later. Use the plus and minus button to adjust the global setback.Legal descriptions are generally prepared by a licensed surveyor, who is trained and authorized to locate and determine the legal description of any property. You can always go back into that dialog to edit your site. ![]() TestFit will close your site and as long as the site is not self-intersecting, the segments aren't too small or have minuscule angles the site will be placed. Don't place your last segment and click apply. The dashed line shows how TestFit will close the site when you are done. As you input your metes and bounds a preview will show on the right-side of the dialog. Input your metes and bounds except for the last segment. Select Metes & Bounds under the site tab. How to draw a site with metes and bounds: Click to finalize the direction of the line then continue to enter the other segments of the site. Click once to start the draw tool then enter the specific length of the segment. How to draw a site with specific dimensions:Ĭlick draw and define the site by left clicking on the site boundaries. Tolerance - Sets an invisible setback an additional amount of defined distanceĬlick draw and define the site by left clicking on the site boundaries.Balcony depth into setback - Allow balconies to protrude into the setback.Global setback - Sets the global setback distance from the defined site line.Draw - draw the property lines (once the nodes are connected TestFit will work to solve).“A”- will transition to site specific editing.All - Tabulation will show the total values for all sites in the plan and lock out the editing of other sites.Sites This is the starting point to define and manipulate sites.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |